West Kermanshah wire and cable laboratory
Bakhtar Wire and Cable Laboratory, located in the production of this company, plays a key and prominent role in advancing the units of this complex in the field of evaluating and improving the quality of the wire and cable industry throughout the country, especially in Kermanshah province. With the approval of the Kermanshah Standards Office, this laboratory can provide laboratory services to other cooperating companies active in this industry.
At Bakhtar Wire and Cable Laboratory, Kermanshah, we have a complete set of equipment required for testing the wire and cable industry. This laboratory conducts precise tests and evaluations according to Iranian national standards and international standards such as IEC, BS, VDE and ISIRI.
In the company’s laboratory, with the help of elite and experienced experts, all relevant tests are carried out in the best possible way in accordance with national and international standards.
With advanced equipment and modern technologies, this laboratory is able to provide accurate and reliable results in the field of analysis and evaluation of wire and cable products.
Working scope of cable Bakhtar laboratory
The scope of work of this laboratory includes a variety of electrical, mechanical and thermal tests that help improve the quality and safety of products. Labs that can be done in western cable
Measuring the thickness of the insulation and coating as well as the overall diameter of the wire and cable
Projector profile device
The purpose of the test is to observe the centering of the wire and cable and measure the thickness of the insulation and sheath, as well as the overall diameter of the wire and cable in accordance with the standard.
One of the points that should be considered when purchasing wires and cables is centering (meaning the center of the conductor or cable core within the insulation and sheath) and the thickness of the insulation and sheath.
To maintain a uniform electromagnetic field, the purchased wire and cable needs to be symmetrical, and if the insulation thickness is less than the standard, problems such as failure to pass the voltage test or even leakage of current from the wire and cable may occur.
Wire and cable heat hardness test
Oven device
Wire and cable tension test
Tensile device
Tensile testing, also known as stress testing, is the most basic type of mechanical test that can be performed on a material. Simply put, this test is performed by pulling the material through the jaws of a tensile tester to determine its response to applied forces. Specifically, when the material is pulled, the ultimate tensile strength (UTS) and elongation (EL) of the material can be determined.
Electrical resistance test of wire and cable
Micro ohm meter device
The electrical resistance of an electrical cable is one of the important parameters for evaluating its quality level. Electrical resistivity is one of the inherent characteristics of elements that determines the amount of resistance that a given material exhibits to the passage of electric current.
A microohm meter is a device for measuring the electrical resistance of objects.
Measuring the concentration of water and soap in the thinning device and also the oil concentration of the rod device
Analog manual refractometer device
These refractometers, which are in the form of a cylinder that work without batteries and have an eyepiece at the end, and by looking through the eyepiece, the user can observe the reflected light from the sample surface on the graduated tape inside the eyepiece, and in this way the concentration of the sample can be calculated.
It is clear that they are extremely easy to use, but the accuracy of this measurement method is far lower than the precise refractometric methods. Its uses in the laboratory unit are to measure the concentration of water and soap in the thinning drawing machine and also the concentration of oil in the rod drawing machine.
Soap water facilitates metalworking operations with ideal lubrication and prevents heat generation by cooling. This oil has anti-rust and anti-foam properties that are suitable for all metalworking operations and is used in many metalworking operations that require a mixture of water and oil.
